So when your chain squirter came out, you just lost all oil pressure or some of it? I have a lot of miles on my build now and I am hoping something like this don't happen. But if it does it would o...
That is where I think I am heading. a .82 housing on my GT30R and some valve springs. Going to try some different cams too. I would like to keep the VET exhaust cam and try swapping intake cams to ...
The new studs are the 220K tensile strength. But they still don't bottom out. Regardless, I have used both kinds and the new set has held up to 26psi without any issues. I am currently using a come...
Ya I don't even know why I have a tps. The car drives just fine without it, and there is no delay in throttle response like some other cars I have had...
I think the car feels more snappy with the higher voltage. You can def notice the response difference, but I still lowered my TPS to read 4V WOT bec...
Mine has done the same thing for over a year. When I hit a certain rpm the oil pressure drops to zero, but the oil light doesn't come on. Crappy sending unit, or engine vibrations... I seems rpm de...
If you guys had a GT30 sized turbo, SC61, HX30, S256 etc... Just something in the same power-level... How well would a .48ar housing work on a 2.0L engine? Since this is the only turbo car I have e...
Now, I can get a .82 housing which will flow good enough for the 550whp that my setup will never be able to make... so the 1.06 may just be really reall...
Took her out tonight. Meh. It builds 15psi by 3700rpm. The exhaust cam made the biggest difference when it switched at around 5500rpm. When the intake switched to 6500rpm you could feel the pick-up...
Okay it is all finished up. Had to eat dinner and finished up before the sun went down. VET cams are in. I will let you all know how the spool and power feels. I expect these to spool a lot faster ...
I am puttin the VET cams back in right now. I will see how they perform compared to the VE cams on the datalogs. Higher maf voltage=more power. Let's see what happens.
Well, how would a setup be affected if you went from a .63ar to a .48? It would prob lose 20-30whp (just a guess). It never clicked to me before, but the pulses that go into each scroll now have on...
I talked to aaron? at full-race today. He agrees that the .78 housing is small. He suggested using the smaller cams as well to see how they react. So I will be doing some datalogging with the VET c...
I understand where the tune is. It leaves some room on the table for sure. But 40whp? No. I'm sure the turbo would spool faster, and make maybe 15-20whp on a pump gas tune. But my timing table and ...
I am 90% sure the housing is the restriction. It would work amazing on the VET cams, but the .78ar when you look at the area of the housing, the insides look way smal...
This setup WILL make 500whp. It will need 24psi to get there though. 15psi highest maf voltage seen was 4.6V. Around 4.7 is 400whp or so. 5V should be aro...