The car is not detonating. Not even close. I will be lowering the timing when I up the boost. I am running about 19* advance on the dizzy right now, but the datascan reveals that the tune pulls all...
1.1bar is max boost for now. Tomorrow I am going too try and hook up the ebay boost controller lol. I am going to have my hot pipe off anyway so I might as well play with more boost.
Yea, the intake cam is switching and it feels really good. You only notice it if I switch it at high rpm. I have it switching at 6k right now and you barely feel it. I tried switching it at 7k and ...
My max timing is only 21*! is this low? cause I was told it should be higher by some tuning guys around here. They said that 21* is safe for over 20psi and pump. I may be raising the boost later do...
DAMN you Jason! How come you gotta jinx me? Well, this radiator is garbage. I spent all day putting it in, but now I gotta pull it out. This sucks. Well, the good news is I can just buy a new one a...
I took some measurements of the tune. Let me know what you guys think about this. My max voltage reading out of the Z32 MAF was 4.50V @ 7400rpm. If you can tell how much air this is flowing, then y...
I redid all the heat wrap on the downpipe. No more melting AC hoses that is for sure. I mounted the NX radiator a everything looks good, but after getting on it really hard I noticed a bit of a coo...
Here is some more info. Base timing is set at about 18* or so. The afr is 10.7 at redline, but about 11.5-12.5:1 throughout the rev range. Peak timing at 7500 is 21* so with a couple degrees in the...
I am at 4500ft. Air up here is thin. My buddy did 340whp on 18 or 20 psi in his srt4 with a 57 trim t3/t4 with a .63ar housing. But there are guys with DETs with gt2871r turbos around here that don...
lol. Ya the p11 has longer legs. And that's not all bad, but the videos don't do this car justice. A car with Ashton's mods up here wouldn't do over 270whp, There are cars with much more modificati...
I took her out for a spin with my 240 friend. He says it is high 300s. Maybe I will dyno her soon. I am going to guess maybe 340whp. If I don't hit over 340whp then I will be changing this manifold...
My buddies disco accelerates like your car in the vid, very hard pull. But I killed him on the freeway. The gearing in my car is not the best, I almost wish I went with the B15 trans instead of the...
checked the tps voltage and got .53 volts closed. I changed it to .38V closed and 4.03 at WOT. I think this will help with power, but I am not sure. I know NA they tell you to set it at .45-.48V bu...
Just checked my AFR and it starts in the 13 range and slowly drops as boost climbs. It stays in a good area of 11.6:1 and goes as lean as 12.7. As soon as it hits 12.7 it drops quickly and by redli...
More videos for your viewing pleasure. These vids are getting on the freeway, you may view them, just don't give me attitude because they are not on a track. None of the videos show street racing, ...
I don't get it, perhaps my boost doesn't hit at a low enough rpm? The car is very fast, and has no traction in first and spins a lil in 2nd. IF i nail 2nd har...
You can check the pump easily by raising your fuel pressure, if the car still leans out then you have a bad filter or pump. If it gets richer by changing the fuel pressure then you know the pump is...
ouch. That is not good. But keep in mind I cannot use the Koyo as stated before. I suppose I could use one, if I didn't want any fans in there lol. The koyo is not the best option for me. It would ...
these fans are rated at 1200cfm a piece. They are 12" slim fans. And the engine has ZERO cooling issues unless the AC is running. I have never had an issue with heat with the factory radiator when ...
Contains unread posts
Contains no unread posts
Thread is closed
You have posted in this thread
Back to top