Coheed's Posts

You're doing it right Ashton. I really like where you've gone with this. I would love to see what this thing would do with N1 cams and 9k rpms. Power will drop off at 8500, but keeping the revs up ...

I did that once to my mom. No video. Only bite marks in my passenger seat as a constant reminder.

I unplugged the AAC and the car idles perfect. No issues at all. So for now, it will stay disconnected. I probably have to do an idle re-learn or swap the valve.

The oil light comes on intermitt...

Are the AAC and IACV actually different? The plugs are similar, and wire colors are identical. The FICD has a different plug, but I wouldn't imagine anything else is really different.

I'm gonna ...

Mods please move to General section.

My B13 project... but I have questions

Yes, just keep in mind that the 4.176 has to have it's mating pinion gear as well (aka main shaft).

If you have a B15 LSD diff, you will need to change the ring gear to work with the P11 transmission. The QG gearstacks are the same as the P11. So if you wanted to use the QG stacks in a B15, you w...

Very impressive stuff. You have a fan. :)

Been to 3 track events thus far. I am loving the balance of the car, but wish it had a tad less understeer under power. Of course, this wouldn't be much of an issue if the car had a bit more power ...

N1 with the 6262 .82 housing... beast.

These wastegates have a few issues with locking open sometimes as well. Glad you got the valve seat in there. If the WG ever locks open on you, take it off and remove the screws from the diaphragm ...

Tapping the housing is nice for having the braided lines, but the housing is really thin and cracks over time. You have to be very skilled, or very lucky to have one last. I'm neither. I used braid...

I have used a set of BC rods and Pauter in my builds. Eagles in other builds. Honestly, if I ever found a rod that needed more machining after getting them, I wouldn't buy it again. These things ar...

Spec V torque steer - Nissan Forums: Nissan Forum

this has been an issue since the spec V was released. It's just the character of the HLSD. Not a lot you can do about it, other than get rid of ...

24 1/8" is the length of the 1994 drivers side axle. The Spec V axle is 24 3/32". This is a completely negligible amount. What lengths are you guys getting between your axles that would warrant an ...

Added some mud guards today. They look pretty good. Very subtle. Going to get a drop and wheels pretty soon guys!

I wish I had more pics. I really wish I would have had a video camera so I could look back at how slow I was lol.

BRZ track experience and impressions

Good lookin' car Ashton. Nice to see it back together.

I've run over 25psi on the blow-thru z32 maf without failure. Not that I'd recommend it, but I did run over 15psi for years with the GT30r without any issues.

You guys may need to improvise in this situation by spacing the mount however you need to by sandwiching washers in place to make sure the alignment is good. Until this gets an official fix from ma...

Wide Open Wednesdays start April 10th. I'll be out at miller motorsports park having some fun with the stock setup before the real fun begins... modifying!

I love my hard top. What a joy!

These are race bearings, and have a little more oil clearance built in. It may be necessary to run thicker oil to compensate. This isn't a bad thing, as these engines output are pushed way beyond f...