Hopefully google can direct people to this thread if they run into the same issue. Either the TAC motor is bad, wiring, or the ECM is dead. Knowing ...
I checked all wiring, relays etc. All checked out good. Nissan covers the computer for 8 years or 80k. My buddy took the car in, and after a little bit of a dealer hissy-fit, they ordered him a new...
At 200whp they are seeing around 14.4 in the 1/4 mile. Street tires. There are some guys wanting to push into the 13s with only 200whp but I've yet to see it.
Well, there's a few guys right now with basic mods knocking on the door of 200whp on pump gas. And a few guys with E85 tunes making over 200whp. The cams will prove to hold back NA numbers. they se...
My buddy and I did a tiny run. He has a g35x. I pulled away just a little bit. I was surprised, as was he. The BRZ does ok. Especially since the BRZ is slow.
I agree the vette is very capable, and very fast. It just doesn't do it for me though... they never have. Great power, but chassis leaves a lot on the table. I wanted a silvia, the brz is by far an...
ya thats a big waste. the brz comes jdm lol. no real bits to add that matter. the hood weighs nothing, and i bet the cf hood and trunk weigh more than the factory parts.
I have tons of 5w40 rotella I bought on clearance a while back. i used it religiously in the sentra. But the suby recommends 0w20. Takes a lot of oil, this engine. 6 quarts or so.
The only problem is where they place the turbo. The forester mounts it below the engine. The BRZ doesn't have the room. The engine sits around 4-5" above the ground, and has a skid plate to protect...
I wish I would have resolved this issue with the sentra. It wasn't ever really that much of a bother, but it never got really bad. I shimmed it to sit a little bit more centered. I ho...
This is getting somewhere! Because without anyone else having a similar issue, this would make hunting down the cause that much more difficult. We need to narrow down whether or not the dealer's mo...
There was another thread that me and Ashton made regarding the axles. It should have all the spline counts in there. You would stand the best chance at getting some Spec V axles from the US shipped...