Coheed's Posts

I'm running the Brembos and they are lighter than the Ad22 setup I had before. The rotational inertia of the larger rotor prob negates much of the weight difference though. 12" rotors.

awesome video. B14s win against hondas! That almost never happens!

You could get the same exact performance of running a step just by making the clutch disk slightly thicker. And I agree, again, that you guys are looking too far into this. The reason the clutch is...

If your clutch is slipping it could just be a crap clutch.

As far as the step goes, it does help increase the clamp load for the factory clutch, but in my experience it just seems to make the clu...

Sprung clutches may blow up every now and then, but it is much easier and cheaper than replacing a whole transmission. Unsprung are very hard on transmissions.

The OEM just have a stamp on them for the main production run in most cases. After so many years of replenishment it will come in a Nissan bag or box.

Its most likely the factory one.

Well, I figure if autozone has a 100% labor guarantee to shops that install these alternators, they must be decent, but they haven't always been that way. The new guys making them seem to be doing ...

You guys make me nervous. :P

I'm running autozone stuff on both my cars for years and never had a problem. Just saying.

Yes, a lightly worked over VE head should flow over 300cfm pretty easily.

Hmmm, someone aspires to be a mailman. ;)

I would go VVL. Allows to rev higher with more availability of parts. GTiR is old tech.

o2 sensors aren't used by the computer for feedback until it goes into closed loop. That's not your problem.

check the CTS because it runs the cold-start program on the board and controls the fuel...

Yes, and yes. Most likely the first yes.

I'd go for something with a drop in status.

I wish. I want to so bad, but I'm having another baby and I just paid for one kid's dentist bill. Out of funds. I just want to get the new radiator in so I can drive it. At least I'll have fun this...

Anyone else have any alignment specs from a recent alignment they can post?

Btw my rear toe with the factory spec V beam is at .15* which I think is very little. Hard to imagine that much toe crea...

You have to have torque to get torque steer.

Just kidding. The VLSD never gave me any torque steer issues, and the difference between the b15 and p11 is very subtle, you only really notice it in 1...

Damn, I wish I could go. I'm only about 5K away from having a good enough suspension. lol. I'm sure the super sentra would perform well though. The ride quality is decent while handling is also dec...

I didn't think they had the 50 series trans available for the SR. Isn't it the same trans as the 5 speed maximas with the Vq30 or something like that?

Basically the GTiR trans but in FWD form?

That is awesome. Where did you get that? Any more pics?

My SAI was 15.9* left and 15.5* right. 15.5* is the max, 14.0 shows as minimum.
Included angle is 14.6 left, and 14.2 right. Range is between 12.7 and 15.7.
Camber is -1.3* and -1.4*

The car is l...

I carry the race heat range 8 and 9 plugs. They are available at local parts stores, but are non resistor plugs. I've run them without any issues, and most of the 1000whp supras around here run the...

let me know how loud they are.

Don't you know by now you can't disclose amounts with your wife? Come on man you should know better lol.

I guess I feel good I don't owe a penny on anything but my house. My car is always paid up ...

I'm not trying to increase the cooling efficiency as much as increase the cooling capacity. I can have the strongest fans in the world, but I'd rather put my money into a larger radiator. Radiator ...