jamie860's Posts

I built my whole se-r using the Classified's on this site. I'm sure many others have too.

Do it ! will be deffinetly be a fun RWD BEAST

Love 240's - If I were to do up an s13, it would look something like this. Nice job :bigthumbup:

what kind of wheels are those?

Put the motor in
Plumbed it for the most part
Ran vac lines intercooler piping and put on the down pipe
Put fluids in it

and I was dreading the 10 hour 570 mile drive, I now feel spoiled.
http://i22.photobucket.com/albums/b319/empirejr/lkbgklbklgbkklhkh.jpg

finally got the bitch off the stand
replaced rear main seal
installed new flywheel/clutch
mated transmission to block
installed solid front dogbone mount
mated crossmember to block

If you don't have a that seal remover tool, a flathead screwdriver will do. Just be gentle with it and you'll be fine.

shit got wild for a while here in the Vernon / Manchester / Ellington area.

yeah- i connected those dots shortly there after posting, i was looking for a picture of a character that looked hungry, and ready. There wasn't much to choose from and I thought Wiley's pic suited...

205/45/15 will fit and yes they will pop out some, some people like it, some don't. Haters gon hate.

Thanks Bes

ah, I just scrolled to the bottom and didn't see sold. Good looks.

If you part it out PM me. Otherwise good luck with sale.

Treat yourself out and buy some N1 cams, they are worth every penny.

Here is a member selling a set in the N/A section for a good price.

http://www.sr20-forum.com/naturally-aspirated/52775-fl-s...

.x2

I see you Valon http://i22.photobucket.com/albums/b319/empirejr/Coyote.gif

I agree that there will be a lot of impressive set-ups, no joke bullshit. I'll be there playing with my car too, as well as filming and taking pictures.

I think through the grape vine i've acquired it?

http://i22.photobucket.com/albums/b319/empirejr/downsized_1216010307b.jpg

degreased the engine-washed
new fuel filter, cap & rotor, spark plugs
mounted distributor, crank pulley, water pump pulley, intake manifold, turbo manifold, turbo, downpipe, wastegate, ran oil lines

replaced Front main seal
replaced rear main seal
replaced driver side axel seal

Canton Midas, give them a call, ask for Jim.

Drill & tapped block
resealed oilpans

I remember auto-cockers they were big when I was young and people shelled out madddddd doh for them. I was too broke so I shot a piranha until I saved up enough an bought an impulse, then a proto ...

Degreased the block, washed.
install BC stage 2's
dropped oil pans-tapping the block tomorrow